Magenta MultiView II T4 Guia de Configuração descarregar pdf (Página 8)

MAGENTA MULTIVIEW™ SERIES

Appendix A. Cabling Pinouts

Table A-2. T568B CAT5 pinout

Table A-3. 1/8” (3.5 mm) Audio Connection

Note: The stereo audio input at the transmitter is summed and output as

mono audio on both channels at the receiver.

Table A-3. DB9 Serial Connection

Pin Channel 1 Channel 2

Tip +

Ring +

Sleeve - -

Serial

Pins

T4S/T5S

Simplex

Tx Tx

Gnd Gnd

APPENDIX B: Sync Termination

Appendix B: Setting Sync Signal Output termination:

In some cases it may be necessary to change the 75 Ohm termination of the sync outputs

on the MultiView 450 units.

This can be accomplished by opening the unit and installing jumpers on the on the circuit

board.

The settings will disable/enable the 75 Ohm termination on individual units. i.e. changing

a transmitter will affect the local monitor port only and not affect receivers. Likewise,

changing a receiver will affect the output port of the receiver and not affect the

transmitter.

The following diagrams show the jumper locations for the T4/T5 transmitter.

Appendix C: Setting Audio Gain Mode:

For compatibility with 450 series receiver units, the audio levels out of the T4/T5 transmitter

may need audio gain disabled (default mode is enabled). Newer AK series and MV series should

use the default mode setting.

1 2 3 4 5 6 7 8

Sem comentários

Magenta MultiView II T4 Guia de Configuração Página 8